In the same command window that you were using in Step 1: Next we’ll use the bootsect utility that comes with Norton Ghost to make the flash drive bootable. Step 2: Make the Drive Bootable ( this is where we start deviating from Kevin’s instructions) When that is done you’ll have a formatted USB flash drive ready to be made bootable. Replace the number ‘1’ with the number of your disk below. Format the drive by typing the next instructions into the same window.I’ll assume that the USB flash drive is disk 1. The number of your USB drive will listed. Find the drive number of your USB Drive by typing the following into the Command Prompt window:.Open a command prompt as administrator (Right click on Start > All Programs > Accessories > Command Prompt and select “Run as administrator”.The steps here are to use the command line to format the disk properly using the diskpart utility. Installed Norton Ghost (this has been tested with version 15, but it should work with 14 also).USB Flash Drive (512mb or larger, 1gb to be on the safe side).The following is an amalgamation of Kevin’s instructions and my adaptation to create the Norton Ghost Recovery flash drive. I used these instructions to transfer Windows 7 to a flash drive when I installed it on my laptop. I found a very good, and simple, set of instructions to create a Windows Vista / 7 bootable flash drive on Kevin’s Blog. The first thing that we need to do is create a bootable flash drive.
#Norton ghost 15 recovery usb how to#
USB flash drives are much faster that CD’s and are read/write, so they can be updated at a later date.Īfter a bit of digging, I’ve figured out how to create one without too much trouble. One of the major problems I’ve had with Norton Ghost is the fact that it only provides the ability to create a recovery CD … it doesn’t provide any ability to install the recovery software on a USB flash drive. Those of you who follow my blog (or know me in person) are well aware that I’m a big fan of Norton Ghost backup software.